Anybody with a Lantac Bolt Carrier?

[csmith]

Good Day, Horde.
Anyone out there have a Lantac bolt carrier and digital calipers? I've seen the design online, but I haven't gotten my hands on one to understand the actual dimensions.

I have a YM National Match Carrier with the following dimensions from the attached pictures. It locks up in the front of carrier very well; however, there is still some play in the rear when locked up.

I am primarily concerned about the very front of the carrier and the very rear of the carrier.

Photos from my NM Carrier are attached.

[ATTACH=CONFIG]14683[/ATTACH][ATTACH=CONFIG]14684[/ATTACH]

[mv1arms]

Lantac enhanced 556 BCG. Rear is 0.978. front near the bolt is 0.940. I tried to make sure I had the same measurement locations as your photos.

[csmith]

Thank you