+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel ARs and Other Semi-Autos (https://65grendel.com/forumdisplay.php?fid=8)
+--- Thread: Anybody with a Lantac Bolt Carrier? (/showthread.php?tid=19600)
Anybody with a Lantac Bolt Carrier? - csmith - 09-21-2019
Good Day, Horde.
Anyone out there have a Lantac bolt carrier and digital calipers? I've seen the design online, but I haven't gotten my hands on one to understand the actual dimensions.
I have a YM National Match Carrier with the following dimensions from the attached pictures. It locks up in the front of carrier very well; however, there is still some play in the rear when locked up.
I am primarily concerned about the very front of the carrier and the very rear of the carrier.
Photos from my NM Carrier are attached.
[ATTACH=CONFIG]14683[/ATTACH][ATTACH=CONFIG]14684[/ATTACH]
Anybody with a Lantac Bolt Carrier? - mv1arms - 09-21-2019
Lantac enhanced 556 BCG. Rear is 0.978. front near the bolt is 0.940. I tried to make sure I had the same measurement locations as your photos.
Anybody with a Lantac Bolt Carrier? - csmith - 09-21-2019
Thank you