04-18-2014, 04:36 PM
You do not want to turn a reamer backwards as you run a risk of dulling it.
I'll be sure to post a "how I did it" when I get this going.
Right now it just entails;
1. High sulfur cutting oil
2. Air compressor to remove cut material
3. T handle to turn reamer
I plan on turning the reamer tell it deadstops on the shoulder.
I'll be sure to post a "how I did it" when I get this going.
Right now it just entails;
1. High sulfur cutting oil
2. Air compressor to remove cut material
3. T handle to turn reamer
I plan on turning the reamer tell it deadstops on the shoulder.