04-04-2014, 10:29 PM
LRRPF52 Wrote:I'll pitch in and I don't even have one of the short chambers. I've been enjoying shooting factory ammo for years without a glitch, and hate to see folks down and out because of this, to be honest.
Thanks for the offer brother,
To be honest I'm alright going this alone but figure there are others inflicted with this issue that are willing to go this route that just need a little push.
Forking up up to $150 far out weighs having this rifle blow up in my wife's face, my face, replacing firing pins, bolts, or the cost's of replacing the rifle, or mabe even brass life in the long run...Lots of negatives in jamming and pressure spikes in an ar and no positives that I can see...to bad this isn't a bolt gun as in that case I wouldn't care.
I'm thinking that since it's already chambered and the throat just needs to be cut a little more I could probably even do this my self with some good cutting oil, the specialty made reamer, and a t handle.