6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Ammunition & Reloading v
Anyone used PP 1200-r to load Grendel? More inside.

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Anyone used PP 1200-r to load Grendel? More inside.
JASmith
Unregistered
 
#28
03-10-2014, 08:44 PM
Might have been less than helpful, but it appears that this responders at least checked the data.

I think liability scares a lot of these folks into a strongly cautious stance.
Thread Closed 


Messages In This Thread
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-05-2014, 02:01 PM
Anyone used PP 1200-r to load Grendel? More inside. - by mseric - 03-07-2014, 05:47 AM
Anyone used PP 1200-r to load Grendel? More inside. - by mseric - 03-08-2014, 03:14 AM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 03:59 AM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 05:53 AM
Anyone used PP 1200-r to load Grendel? More inside. - by ragedracer1977 - 03-08-2014, 07:38 AM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 03:33 PM
Anyone used PP 1200-r to load Grendel? More inside. - by ragedracer1977 - 03-08-2014, 04:00 PM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 04:15 PM
Anyone used PP 1200-r to load Grendel? More inside. - by mseric - 03-08-2014, 04:39 PM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 04:50 PM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-08-2014, 05:50 PM
Anyone used PP 1200-r to load Grendel? More inside. - by biggdawg - 03-08-2014, 09:20 PM
Anyone used PP 1200-r to load Grendel? More inside. - by mseric - 03-08-2014, 10:42 PM
Anyone used PP 1200-r to load Grendel? More inside. - by woohoo - 03-08-2014, 11:14 PM
Anyone used PP 1200-r to load Grendel? More inside. - by mseric - 03-10-2014, 07:08 PM
Anyone used PP 1200-r to load Grendel? More inside. - by JASmith - 03-10-2014, 08:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)