07-20-2011, 03:48 PM
Here are a few pictures of 6.5 grendel rounds in my Lancer 20. I apologize for the lousy picture quality. The internal rib dimensions on the Lancer will probably be very close to those of the pmag, so I predict a similar fit of grendel rounds in the pmag.
One round fit fine. Two rounds didn't quite stack properly, but it looked like it would feed. At three rounds, I experienced some mag bulge. At four rounds, as shown here, the mag was markedly bulged. When I squeezed the mag to see if it would fit in a magwell, three rounds simply flew out of the mag.
[ATTACH=CONFIG]292[/ATTACH][ATTACH=CONFIG]293[/ATTACH][ATTACH=CONFIG]291[/ATTACH]
One round fit fine. Two rounds didn't quite stack properly, but it looked like it would feed. At three rounds, I experienced some mag bulge. At four rounds, as shown here, the mag was markedly bulged. When I squeezed the mag to see if it would fit in a magwell, three rounds simply flew out of the mag.
[ATTACH=CONFIG]292[/ATTACH][ATTACH=CONFIG]293[/ATTACH][ATTACH=CONFIG]291[/ATTACH]