6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Troubleshooting v
chamber issue

Linear Mode
chamber issue
DHumbarger
Unregistered
 
#8
06-23-2012, 12:49 PM
Can't really tell from the photo but the reamer might have caught a chip & gouged the chamber wall (worst case). Can you feel a ridge when you run your fingernail over that ring? The other possibility is that the chamber just needs polishing. I hope it is the latter.
Reply


Messages In This Thread
chamber issue - by PumpActionJackson - 06-13-2012, 02:37 PM
chamber issue - by PumpActionJackson - 06-13-2012, 02:38 PM
chamber issue - by PumpActionJackson - 06-13-2012, 02:39 PM
chamber issue - by PumpActionJackson - 06-13-2012, 02:39 PM
chamber issue - by LRRPF52 - 06-13-2012, 02:43 PM
chamber issue - by StoneTower - 06-13-2012, 02:45 PM
chamber issue - by PumpActionJackson - 06-13-2012, 02:48 PM
chamber issue - by DHumbarger - 06-23-2012, 12:49 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)