What you guys think about J&T?

[MrSurgicalPrecision]

Mad Max,

I just looked at that trigger on Rainier's site ( I order from them often ), and it was hard to tell what allows that trigger to adjust for over-travel and creep. Is it like a JP with 2 set screws? If so, I think I might try one for my next running gun. That Mega trigger combined with the DPMS LPK(-) sounds like the most affordable LPK plus match trigger right now, but you will need a hammer in addition to those two items. Thanks for the heads up on those.

I use 2-stage for precision guns, and single stage for carbines that will usually be shot from standing or moving positions. I didn't realize that Mega's trigger was adjustable. When I install the JP's, I polish the sear surfaces of the trigger and hammer using my well-seasoned degree in hand-held, high-speed, rotary tool applications... Just make sure you don't take too much material off your trigger bar in the rear when you fit it to the selector...I had a friend that did it once...

LRRPF52

It has a set screw fore and aft that screws down against the bottom of the receiver and adjusts it's position. The front screw adjusts overtravel, the rear adjusts the amount of creep. I've got mine set to the minimum that will still allow it to function properly and it's far better than the Chip McCormick drop in my buddy just put in his Grendel. But like I said I don't like 2 stage triggers.

I can probably email you the installation instructions which shows it better than I can explain it if you're interested.

EDIT: I forgot about this video.

http://www.youtube.com/watch?v=81mpvsDGHSg