05-03-2023, 08:20 PM
Just purchased a 14.5 Lilja and bolt from rebby over at Six Sigma. Gathering up the last few pieces to finish up this build. Im needing a gas block and tube. This build will be suppressed most (if not all) of the time. Im trying to decide to go with an adjustable gas block or a standard gas block and BRT eztune gas tube.
I have a superlative block on another build but with this being a pin and weld I like the idea of being able to swap the tube out if needed rather than pull the handguard off to adjust the gas. I know itd only have to be adjusted once but the simplicity of the system using the brt tube is intriguing. Has anyone ran an eztune tube on a 6.5G, especially a Lilja?
I have a superlative block on another build but with this being a pin and weld I like the idea of being able to swap the tube out if needed rather than pull the handguard off to adjust the gas. I know itd only have to be adjusted once but the simplicity of the system using the brt tube is intriguing. Has anyone ran an eztune tube on a 6.5G, especially a Lilja?