Ok here goes some results. I loaded the 120eldm with a ladder of ar comp. This bullet is touching the lands of my 20 PF criterion at 1.645 cbto, and 2.190 coal. So I loaded .020 off them which was 1.625 cbto. I started my ladder at 26.0 in .2 increments and went to 26.8. Its a short ladder I know because i could hear powder being compressed for sure at 26.6 so being on the uneasy side I stopped at 26.8. Anyways temperature was 90 and very humid, velocities was as follows
26.0 - 2417
26.2 - 2418
26.4 - 2443
26.6 - 2447
26.8 - 2457
I split the middle and loaded 26.6. Speeds was 2429, 2435, 2427. Only a 3 shot Group and was roughly 1 es of 8, sd of 4. Couple of questions.
1. I noticed my speeds was up there for a low charge. Was it because the load was compressed ?
2. Would you run a seating depth test going closer to the lands to help with the compression ?
3. Pick a different bullet ?
Thanks
26.0 - 2417
26.2 - 2418
26.4 - 2443
26.6 - 2447
26.8 - 2457
I split the middle and loaded 26.6. Speeds was 2429, 2435, 2427. Only a 3 shot Group and was roughly 1 es of 8, sd of 4. Couple of questions.
1. I noticed my speeds was up there for a low charge. Was it because the load was compressed ?
2. Would you run a seating depth test going closer to the lands to help with the compression ?
3. Pick a different bullet ?
Thanks