Erik Cortina Tuner
|
Erik Cortina Tuner
|
07-01-2022, 11:44 AM
The forces I have experienced came from using a crush washer. Since the washer does not align totally concentric and since it deforms (radial-wise) non-uniformly, it puts a non-concentric force on both the muzzle device and the barrel-tip. For any muzzle device I now use either an accuwasher system or jam nut to keep everything uniform around the bore and barrel.
"Down the floor, out the door, Go Brandon Go!!!!!"
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Erik Cortina Tuner - by JCart - 05-21-2022, 10:20 PM
Erik Cortina Tuner - by Paringa - 05-24-2022, 07:54 AM
Erik Cortina Tuner - by Klem - 05-24-2022, 11:03 AM
Erik Cortina Tuner - by Happy2Shoot - 05-24-2022, 08:17 PM
Erik Cortina Tuner - by Klem - 05-24-2022, 09:36 PM
Erik Cortina Tuner - by montana - 05-24-2022, 10:10 PM
Erik Cortina Tuner - by Happy2Shoot - 05-25-2022, 06:06 PM
Erik Cortina Tuner - by Happy2Shoot - 05-25-2022, 06:14 PM
Erik Cortina Tuner - by montana - 05-25-2022, 06:56 PM
Erik Cortina Tuner - by Remington Jim - 06-28-2022, 05:49 AM
Erik Cortina Tuner - by Happy2Shoot - 06-28-2022, 09:05 PM
Erik Cortina Tuner - by JCart - 06-30-2022, 03:49 PM
Erik Cortina Tuner - by Growler - 06-30-2022, 05:07 PM
Erik Cortina Tuner - by grayfox - 07-01-2022, 11:44 AM
Erik Cortina Tuner - by Remington Jim - 07-01-2022, 03:14 PM
Erik Cortina Tuner - by JCart - 07-02-2022, 03:46 AM
Erik Cortina Tuner - by TickTock - 09-12-2022, 09:16 PM
Erik Cortina Tuner - by JCart - 10-21-2022, 07:30 PM
Erik Cortina Tuner - by JCart - 06-08-2022, 04:06 PM
|
