11-25-2020, 03:32 AM
OK so I did measure the bolts of JP and Toolcraft to be within 2 mils.
I am now using carrier from Toolcraft and inserting a bolt from JP there for 6.5G build.
one thing that immediately bothered me is: after I assembled the BCG, when i fully retract it and then place vertically face down, it slides back under own weight.
is it a problem or not?
If I am correct I heard that if that happens then its time to change bolt rings... but this is brand new bolt.. any ideas if i should ignore it and all good, or ?
I am now using carrier from Toolcraft and inserting a bolt from JP there for 6.5G build.
one thing that immediately bothered me is: after I assembled the BCG, when i fully retract it and then place vertically face down, it slides back under own weight.
is it a problem or not?
If I am correct I heard that if that happens then its time to change bolt rings... but this is brand new bolt.. any ideas if i should ignore it and all good, or ?