03-26-2012, 02:52 PM
MrDraco: As LRRPF52 said above your post " AR Stoner is CProducts with an "AR Stoner" (Midway) floor plate.".
Hopefully a new mag manufacturer will come on board in the future but as of right now there is only one manufacturer no matter what label is put on the floorplate.
Opus Dei: Was the magazine you bought new in the wrapper? Where or through whom did you purchase the mag. from?
I have 12( at least) of the 25 round mags. and none of them bulge or have fitting problems in the magwell.
What lower are you using and is it possible the magwell is out of spec.?
I've heard of this before.
Have you loaded the mag. completely full?
Sometimes I've heard of people having mag. problems, although these weren't 6.5 Grendel mags., because the spring hadn't been compressed yet. So they filled the mag. and let it sit for a couple of days to compress the spring.
It may be worth a try.
Hopefully some of this helps.
Good luck.
Lee
Hopefully a new mag manufacturer will come on board in the future but as of right now there is only one manufacturer no matter what label is put on the floorplate.
Opus Dei: Was the magazine you bought new in the wrapper? Where or through whom did you purchase the mag. from?
I have 12( at least) of the 25 round mags. and none of them bulge or have fitting problems in the magwell.
What lower are you using and is it possible the magwell is out of spec.?
I've heard of this before.
Have you loaded the mag. completely full?
Sometimes I've heard of people having mag. problems, although these weren't 6.5 Grendel mags., because the spring hadn't been compressed yet. So they filled the mag. and let it sit for a couple of days to compress the spring.
It may be worth a try.
Hopefully some of this helps.
Good luck.
Lee