6.5 Grendel Forum › GENERAL FIREARMS DISCUSSION › Cartridges v
forming 6mmGrendel

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
forming 6mmGrendel
Zeus Offline
Member
***
Posts: 92
Threads: 9
Joined: Mar 2018
#7
03-21-2020, 10:51 PM (This post was last modified: 03-21-2020, 10:53 PM by Zeus.)
Bat Rastard Wrote:I ordered a set of neck sizing bushing dies. Am I screwed?

I use a .268 bushing (as recommended by Robert Whitley himself) in one step to form my brass....(good lube is your friend)....The bushing is in a Redding 6.5 Grendel FL bushing die. You could use a neck die only but I suspect you'd need to FL resize sooner or later.....
Find
Reply


Messages In This Thread
forming 6mmGrendel - by Bat Rastard - 10-06-2019, 02:13 AM
forming 6mmGrendel - by bachekermooni - 10-06-2019, 11:14 PM
forming 6mmGrendel - by Msalm - 10-12-2019, 01:46 AM
forming 6mmGrendel - by RiverRider - 10-15-2019, 04:15 PM
forming 6mmGrendel - by mopar_4life - 03-21-2020, 01:17 AM
forming 6mmGrendel - by Lawrence97 - 03-21-2020, 08:34 PM
forming 6mmGrendel - by Zeus - 03-21-2020, 10:51 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)