10-15-2019, 04:15 PM
I am using a Redding FL/Bushing die with a nitride bushing. .268" IIRC. I removed the expander button...better off without it, IMO.
I found that necking down once-fired 6.5G brass was pretty bumpy, but went smoothly when the fired cases were resized in a regular 6.5G FL die before necking down in the bushing die. New 6.5G brass was not a problem, just necked it down right out of the package.
I found that necking down once-fired 6.5G brass was pretty bumpy, but went smoothly when the fired cases were resized in a regular 6.5G FL die before necking down in the bushing die. New 6.5G brass was not a problem, just necked it down right out of the package.