10-07-2018, 12:33 PM
A5BLASTER Wrote:Hard for me to tell but looks like the fireing pin jyst didn't strike it hard and deep enough.
Maybe something to do with the trigger/hammer springs sitting up for so long.
Maybe some trash in the fireing pin channel?
Take the bcg apart and give it a good cleaning and check see if any trash in the lower around the trigger and hammer, might be as simple as that.
Hope you figure it out.
Not hard for me to tell.
Light primer strikes is exactly correct.
I doubt it is crud in the firing pin hole but could be crud in other places.
Suggestion.
Take upper from lower.
Hose out lower with brake cleaner and lube trigger parts again.
Remove bolt from carrier and clean both. Lube as necessary.
Put back together and my bet is the problem will be solved.
LR55