Bolt Action AR upper in 6.5 Grendel

[bj139]

I had a spare stripped bolt without gas rings and installed it in a carrier.
Without gas rings there is almost no friction.
I am looking at where I can buy a spring of the right size locally.
I will definitely try these small improvements.

Edit: I am about to head over to Lowes with my BCG to look at this.
Maybe stainless steel if used in a sink.
https://www.lowes.com/pd/Danco-SEATS-and...EX/1082005

Edit again: I bought this.
https://www.lowes.com/pd/Danco-1-Handle-...ta/4764823
Here is my new manual ejection Grendel bolt. I think I will paint the visible side of the bolt carrier FDE so I know which one it is without removing it from the receiver.

Painted it.

I switched the LANTAC like bolt into my Grendel 16" BCA side charging upper. It seemed more practical for a faster second shot.
I removed the gas block and gas tube. I may go shoot it tomorrow.
I put a few cases fired in another Grendel into the chamber and slammed the bolt shut. It extracted them very easily steel case and brass case.