10-31-2011, 04:40 PM
I was thinking of doing that exact thing, but I think there is room for improvement in the chemical composition of the water transfer prints as well, along with the activator. It would be a game-changer if someone did what I would do, but I don't have a degree in chemical engineering. I'll bet they're already working on it though.
When I was in the Army, I used Rustoleum textured paint on my furniture and rail covers, then applied tons of flat matte clear over it for protection, which worked ok. It never glossed-up with use, which was my intent. Here's a better pic of that method:
[ATTACH=CONFIG]535[/ATTACH]
The reason was because Bowflage comes right off with regular use and especially rain.
When I was in the Army, I used Rustoleum textured paint on my furniture and rail covers, then applied tons of flat matte clear over it for protection, which worked ok. It never glossed-up with use, which was my intent. Here's a better pic of that method:
[ATTACH=CONFIG]535[/ATTACH]
The reason was because Bowflage comes right off with regular use and especially rain.