05-10-2015, 07:07 PM
Powders:
8208 - in .5 increments from 25 - 28.5
CFE 223 - in .5 increments from 26.5 - 31.5
IMR 4198 - in .5 increments from 23 to 24
H322 - in .5 increments from 24.5 - 26.5
Ramshot TAC - in .5 increments from 24 - 27.5
X-terminator - .5 increments from 24 - 28
Bullets used 123 NCC, 123 Amax, 107 SMK
Primers used CCI 450 CCI BR-4 Rem 7 1/2 CCI 41
Brass used Lapua
I have ran through just trying to find a load near three hundred bullets. So to give you exact load data of each one would be a very big pain in the rear.
On the over torque/ under torque issue tried it. Trueing the receiver, done it. Switching scopes I've tried three different ones, from NF to Vortex Razor and Vortex PST.
I'm about to turn this barrel into a play thing for my lathe.
Anyone have info on the Brownell's barrel???
8208 - in .5 increments from 25 - 28.5
CFE 223 - in .5 increments from 26.5 - 31.5
IMR 4198 - in .5 increments from 23 to 24
H322 - in .5 increments from 24.5 - 26.5
Ramshot TAC - in .5 increments from 24 - 27.5
X-terminator - .5 increments from 24 - 28
Bullets used 123 NCC, 123 Amax, 107 SMK
Primers used CCI 450 CCI BR-4 Rem 7 1/2 CCI 41
Brass used Lapua
I have ran through just trying to find a load near three hundred bullets. So to give you exact load data of each one would be a very big pain in the rear.
On the over torque/ under torque issue tried it. Trueing the receiver, done it. Switching scopes I've tried three different ones, from NF to Vortex Razor and Vortex PST.
I'm about to turn this barrel into a play thing for my lathe.
Anyone have info on the Brownell's barrel???