6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Build-It-Yourself & Custom Builds v
new build

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
new build
LRRPF52 Offline
Super Moderator
Posts: 8,507
Threads: 241
Joined: Sep 2014
#10
12-20-2014, 10:03 PM
When aligning gas blocks, I use the protrusion gauge at the end of the calipers inside the block to see where center of hole is.

Then I measure from the barrel shoulder to the gas port center. Most blocks need to be set off from the shoulder, while some will abut right up to the shoulder no problem.
NRA Basic, Pistol, Rifle, Shotgun, RSO

CCW, CQM, DM, Long Range Rifle Instructor

6.5 Grendel Reloading Handbooks & chamber brushes can be found here:

www.AR15buildbox.com
Website Find
Reply


Messages In This Thread
new build - by tackdriver - 12-19-2014, 01:35 PM
new build - by am4966 - 12-19-2014, 02:28 PM
new build - by Slappy - 12-19-2014, 02:45 PM
new build - by LRRPF52 - 12-20-2014, 12:47 AM
new build - by tackdriver - 12-20-2014, 12:58 AM
new build - by Heywood - 12-20-2014, 02:58 AM
new build - by olde sarge - 12-20-2014, 04:48 AM
new build - by Heywood - 12-20-2014, 06:13 PM
new build - by tackdriver - 12-20-2014, 07:10 PM
new build - by LRRPF52 - 12-20-2014, 10:03 PM
new build - by Heywood - 12-21-2014, 04:00 AM
new build - by tackdriver - 12-21-2014, 02:45 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)