Low Mass BCG cotter pin protrusion?

[CJW]

Guys,

Got my new low mass BC from Right To Bear Arms yesterday.

It is much thinner in the area where the firing pin cotter pin is mounted.

As a result the cotter pin sticks out much more than on the standard BCG.

Is this something I should be concerned about?

Chuck

[A5BLASTER]

Hasn't been a problem with any of mine.

If it should cause a problem. Bout 5 seconds on a grinder will fix it right up.

[CJW]

Blaster,
I was hoping you would read this.

Thanks,
Chuck

[82HALO]

Using these also with no problems!