+- 6.5 Grendel Forum (https://65grendel.com)
+-- Forum: 6.5 GRENDEL DISCUSSION FORUMS (https://65grendel.com/forumdisplay.php?fid=3)
+--- Forum: 6.5 Grendel Troubleshooting (https://65grendel.com/forumdisplay.php?fid=15)
+--- Thread: Low Mass BCG cotter pin protrusion? (/showthread.php?tid=19994)
Low Mass BCG cotter pin protrusion? - CJW - 11-20-2019
Guys,
Got my new low mass BC from Right To Bear Arms yesterday.
It is much thinner in the area where the firing pin cotter pin is mounted.
As a result the cotter pin sticks out much more than on the standard BCG.
Is this something I should be concerned about?
Chuck
Low Mass BCG cotter pin protrusion? - A5BLASTER - 11-21-2019
Hasn't been a problem with any of mine.
If it should cause a problem. Bout 5 seconds on a grinder will fix it right up.
Low Mass BCG cotter pin protrusion? - CJW - 11-21-2019
Blaster,
I was hoping you would read this.
Thanks,
Chuck
Low Mass BCG cotter pin protrusion? - 82HALO - 11-24-2019
Using these also with no problems!