Posts: 61
Threads: 2
Joined: May 2019
For those of you who have the new stock I need you input before I pull the trigger. Some of the pictures on this site of that stock seem to show that the area of the stock below the reciever in front of the triggerguard appears to have a square edge to it vs. being more rounded. So that is my question, is the stock in that area squared or rounded. The BC website does not give a clear picture but it appears to be more rounded which I hope it is, square in that area does not work for me. Thanks
Posts: 37
Threads: 2
Joined: Feb 2020
Posts: 749
Threads: 35
Joined: Dec 2019
see my (poor) photo of the sporter B&C in the Jefferson Outdoors post. at the action area on my B&C sporter stock, it is a bit more square than round. and i think i too would have preferred it a bit more rounded than it is. Even so, the B&C sporter is still so much better than the tupperware stock that comes from the factory. teamed up with JO flush bottom metal, it's how i wish Howa would have sold it in the first place.
take care,
-tdbru
Posts: 61
Threads: 2
Joined: May 2019
Thanks for the input gentleman. I have already done a lot of work on the Hogue stock and actually have it trimmed down pretty much to my liking in addition the rifle is suprisingly accurate in this stock. I am just intrigued with the full bedding block and better finish of the B&C. As someone said earlier this attempted inexpensive foray into the Grendel is going to get expensive but due to the action and accuracy it's going to be worth it.
