06-24-2018, 09:58 PM (This post was last modified: 07-24-2018, 09:07 PM by LRRPF52.)
Five sets of 5 rounds at a spirited pace. I started a stop watch but was so pissed off by the time I was done I forgot to check it. Probably about 1:15. I shoot 350 to 550 steel faster with a dialed in 223.. Group 5 aiming point was top right corner. The sixth target was after cooling 20-30 minutes - back to zero (which was a little low because rifle is zero'd off of handguard on bag). These were shot off bipod.
I don't have pictures, but shot same pace with my 20" slim contour BHW - 0.625" to 0.750" rifle length gas journal then back to 0.625" until it flares near muzzle. Started moving down a tad at 12-13 rounds then settled at 2 MOA low. 20 rounds gets a slim contour barrel pretty damn warm.
This was with a Strike Industries handguard with steel barrel nut (came off of the McGowen 6mm build after I took it behind the shed). Results were worse with the Faxon handguard (that contributed an extra 2 MOA when things got warm), but the barrel is the main culprit.
I find it hard to believe that this company could still exist basing their product on a lie.
I find it even harder to believe that Rainier Arms, who hangs their shingle as being a premium supplier, would carry this garbage.
I find it hardest to believe that I got suckered into buying this steaming pile of crap when my original intent was to buy a JP.
Rainier is getting a call first thing in the morning and I am going to attempt to return it as a defective product. It's been slightly over 30 days, but this thing is worthless to anyone who doesn't stop to have a cup of coffee between 5 shot groups.
My apologies to anyone who might have listened to any of my previous positive comment. Yes, it still is extremely accurate for 5 or so shots when cool. Lucky for you, you're probably within Rainier's 30 days.
This is what they say on Rainier's website: "Drilled to vent heat-fastest cooling carbon fiber barrel" Blatant false advertising implying it cools faster than a Proof. I didn't believe THAT, but I would have thought it work somewhat.
Here's another set. After zeroing with the temporary handguard, I neglected to see the wind was blowing in 2 directions and missed the first 2 shots on a 4" diamond at 250. The next 3 were hits. It takes some time in between shots to wait for the target to stop swinging. I then went to my software and changed to the 6" diamond at 460. Went 4 of 5. Again, some time in between shots to let it stop swinging. I stopped, loaded up the 10 round mag and went back to the 460. Low and left. Adjusted and kept on going low and left after further adjustment. After 6 misses, I went to paper at 100. The zero is good since I was going off the bag:
06-25-2018, 06:20 AM (This post was last modified: 06-25-2018, 06:24 AM by The Profit Joseph Sith.)
I was wondering if this was from Rainier from your other thread. they are pretty good they SHOULD give you a refund. And it will probably be in their "bargain bin" which isnt all bad, they are about 20 mins from me and theres some screaming deals in there sometimes but ive wondered about the barrels. I KNOW they have a return policy on their own branded barrels. I found my v seven steel buffer tube in there for like $45 didnt even know someone made a steel tube. I had to have it! Things awesome btw.
Im kinda leaning in A5's direction. A few months ago i wetted my toes with a JP .22 barrel and bolt kit. You never see these things and i was too curious i had to try one. Got the lapua/sk standard norma and federal GM HV all stocked up now just waiting for ALG to finally ship my 4 HG's i ordered memorial day..
For my next build i think ive settled on the JP 6.5 creed just want to get it done before these a holes ban them. Im SOO stoked they going to be at this years triggrcon, only racked one once before and they are as solid as the kobalt kinetics AR's.
I never understood this expression. I figure that if you are crying at all, then you probably made a bad decision. Money well spent is nothing to cry over.
A5BLASTER Wrote:You or correct my friend that's why I run JP and if I get away from JP it will be a Lilja, bartlein or kreiger but most likely a lilja.
Somebody has to try these products. We want to see new/different manufacturers with Grendel offerings. If folks only purchased from one or two places, then nobody else would be entering the market.
Double Naught Spy Wrote:I never understood this expression. I figure that if you are crying at all, then you probably made a bad decision. Money well spent is nothing to cry over.
Somebody has to try these products. We want to see new/different manufacturers with Grendel offerings. If folks only purchased from one or two places, then nobody else would be entering the market.
Yes sir I understand that completely, and I'm all for more offerings of the grendel.
It just seems like some company's are jumping on the wagon that is the ever growing popularity of the 6.5 grendel and not doing much in the way of making sure their products are of atleast shall we say possible results typical of this caliber.
I'm not against buying a budget barrel, I just hate to see, products come out that have clearly only been produced to try and grab a quick share of the market and not built with any care.
Now saying all that I will be the first to admit that even top shelf company's can drop the ball from time to time and let a less then steller product slip out the door.
Well, I called twice this morning and no one picked up the phone on the returns line. Went into request returns on their website, checked off the barrel, marked "open" for condition (there is no "used" option), selected "other" as reason (there is no "defective" option) and store credit as resolution. Explained the massive amount of thermal drift in comments and uploaded the pictures. Return was instantly accepted. Time to break it down as quick as possible, package it up and head to the office to print the return label and get it out the door! Maybe BSF barrels are set up for automated return acceptance. Still don't know if they'll accept it since it's "used" and not "open", but possession is 90%!
StoneHendge Wrote:Well, I called twice this morning and no one picked up the phone on the returns line. Went into request returns on their website, checked off the barrel, marked "open" for condition (there is no "used" option), selected "other" as reason (there is no "defective" option) and store credit as resolution. Explained the massive amount of thermal drift in comments and uploaded the pictures. Return was instantly accepted. Time to break it down as quick as possible, package it up and head to the office to print the return label and get it out the door! Maybe BSF barrels are set up for automated return acceptance. Still don't know if they'll accept it since it's "used" and not "open", but possession is 90%!
Hope it works out for you sir.
Keep us posted on how it goes.
Any thoughts on what barrel you going to replace it with?
Any thoughts on what barrel you going to replace it with?
Thanks and will do. I'll probably do a JP like my original plan, but Proof Research is in the back of my mind. Having a credit makes it more palatable but I know I can spend that easily on other goodies. Proof's technology works - my 24" S'more cools faster than my 22" JP Grendel with dissipator.
I never understood this expression. I figure that if you are crying at all, then you probably made a bad decision. Money well spent is nothing to cry over.
Perhaps you are overlooking the spousal effect.
To whit:
[ATTACH=CONFIG]12146[/ATTACH]
If it's true that we are here to help others, then what exactly are the others here for?
. Still don't know if they'll accept it since it's "used" and not "open", but possession is 90%!
