Rem 700SA 6,5 Grendel project.

[mtnlvr]

Looks like a fun project! Nice work!

[biodsl]

Thank you for updating this thread. A member over on Snipers Hide was wondering if anyone has done this (SA bolt action typically for larger caliber) with the Grendel. I have yet to do up my MPA Comp. I need to bore a bolt for the case, and get a barrel cut.

Here's one of my favorites; a Grendel built on a Savage Scout donor chambered in 7.62x39. Same SA as the 308 family of cartridges.

https://www.65grendel.com/forum/showthre...ght=savage

[Second]

A little update.

I did a post previous where I put lead-pellets inside the KRG Bravo to add weight.
It have worked wry well and no moving what so ever on any if the places.

Now I have removed all of them I it also worked extremely well!
All released from the stock without any problems but with a very tight and snug fit.
So if I want and need to add weight to the stock again, I can very easily do so.

Here are the parts after removal:
[ATTACH=CONFIG]17711[/ATTACH]
[ATTACH=CONFIG]17712[/ATTACH]

To remove some of them, I drilled a small hole and screwed in a wooden screw and then just pulled them out.
The one on the underside of the forend I needed to use a hammer and tap it out. But that worked also very well.

[hill37]

A little off topic but I wonder if the new Remington management would consider making a Model 7 factory Grendel/ 6mmArc.

[Old Bob]

A little off topic but I wonder if the new Remington management would consider making a Model 7 factory Grendel/ 6mmArc.

I could dig it!