10-14-2014, 01:19 AM
Thanks for the replies.
Regarding the reaming, a 29/32 reamer is .90625 diameter. Do you think this could ream a .875 hole which is not completely surrounded in steel (the clamp is a split ring) to .90625?
How would you support the .875 split ring clamp gas block to minimize flex while reaming? I'm thinking of using a 4 jaw rotary table on the mill as a possible way of doing this.
Regarding the reaming, a 29/32 reamer is .90625 diameter. Do you think this could ream a .875 hole which is not completely surrounded in steel (the clamp is a split ring) to .90625?
How would you support the .875 split ring clamp gas block to minimize flex while reaming? I'm thinking of using a 4 jaw rotary table on the mill as a possible way of doing this.