08-18-2014, 11:37 PM
montana Wrote:[ATTACH=CONFIG]5479[/ATTACH][ATTACH=CONFIG]5480[/ATTACH]
I used the SLR clamp on gas block with the MI keymod 15" hand guard with this rifle. It was a close fit but the screws did not touch the inside of my hand guard. This is a very accurate rifle and I have had no issues with this gas block and hand guard combination.
Make sure you put green loctite on the outside of your barrel nut when mounting this hand guard or it may walk forward during recoil and don't over tighten the hand guard nuts or you may break the rear nubs that fit in the barrel nut.
Thanks a bunch! I'll let you know how this goes. MI indicated that it may depend on where the gas block is in the hand guard (holes in the hand guard being over the screw heads) depending on length of gas system/hand guard length. Thanks again. Much appreciated.