06-18-2014, 03:13 PM
What kind of action are you wanting to put it on? As Mongoosesnipe said, the OD (outside diameter) of most AR15 barrels is ~1", the max OD of most threads for most bolt actions is about 1" or just a touch over. I think stock remington 700's are 1 x 16tpi, Savages are something like 1.055 x 20 tpi. So you could maybe pull it of with a Savage, but I have my doubts. You would have to cut off the existing threads, then start a new chamber and thread job. I'm not sure if you'd have a long enough section at 1" to accomodate the barrel nut on savage actions. Not to mention you'd be .055" under size on the OD of the threads.
So short answer, No, probably not, unless there is some other action that uses a threaded shank that's closer to what the AR15 barrel extension uses. Might as well just buy a .264 caliber barrel blank.
ETA: As for going to an AR-10 platform, you're in the same boat as above. AR10 barrels are thicker towards the rear, larger threaded area etc. Not to mention I wouldn't want to try and stuff a .260 into an existing Grendel barrel dimension. I can live without high velocity body piercings.
So short answer, No, probably not, unless there is some other action that uses a threaded shank that's closer to what the AR15 barrel extension uses. Might as well just buy a .264 caliber barrel blank.
ETA: As for going to an AR-10 platform, you're in the same boat as above. AR10 barrels are thicker towards the rear, larger threaded area etc. Not to mention I wouldn't want to try and stuff a .260 into an existing Grendel barrel dimension. I can live without high velocity body piercings.