Here's a quick phone snap shot for now. Pay no attention to the red nipple, that's Lilja's thread protector for shipping.
![[Image: s2snld.jpg]](http://i61.tinypic.com/s2snld.jpg)
Currently its wearing a thread protector made by a local shooter, and it will have a Killer Innovations (http://www.shop.killer-innovations.com/3...tdtblk.htm) brake on it soon.
![[Image: 2eek9jm.jpg]](http://i58.tinypic.com/2eek9jm.jpg)
The AR Stoner BCG is going to be replaced with a PSA premium as of tomorrow. The scope mount ended up being a SWFA SSALT mount, same as the PEPR only $20 cheaper. The gas block is a Troy low profile.
Think that fills in most the info that was left out of the OP.
Oh yea, and its become apparent that I need a bigger charging handle. Probably end up with a BCM mod 3 (large).
Currently its wearing a thread protector made by a local shooter, and it will have a Killer Innovations (http://www.shop.killer-innovations.com/3...tdtblk.htm) brake on it soon.
The AR Stoner BCG is going to be replaced with a PSA premium as of tomorrow. The scope mount ended up being a SWFA SSALT mount, same as the PEPR only $20 cheaper. The gas block is a Troy low profile.
Think that fills in most the info that was left out of the OP.
Oh yea, and its become apparent that I need a bigger charging handle. Probably end up with a BCM mod 3 (large).