05-06-2014, 03:38 PM
Final update!! they're must have been a burr, I put a couple drops of oil, closed my eyes and turned a little harder, it went on no problem!
jurassic Wrote:I just bought one of the ones from Redxarms, it had lots of "shelf" wear, and the engravings for the barrel caliber, twist rate, and the other markings look to have been done by hand or a worn out machine. I suspect these barrels were made in limited numbers. It does'nt bother me as I was going to have it Cerakoted or something similar.
I was told the 9/16 x 24 brake or flash hider should fit, but mine does not. They said its because of the finish, I will probably run a die over it, I've never had this problem before.