Observations.
At 28.3 gr. I started to notice slightly flattened primers, oddly at the time 28.5 gr only showed one slightly flattened primer only with the SST. Probably not an accurate measuring on my part. (May have spilled a bit out pouring into the case. I say that since the velocity was so low on two of them and i didn't have flattened primers on two of them.)
I think I will try and load more from 28.2 - 28.5 with .1 gr difference and see which one works out the best. Hopefully from a more sturdy rest on a less windy day.
Also, 26.1 gr. from the Nosler load data seemed to be pretty accurate only 200 FPS slower than close/near to max. I may use that as my nosler plinking fun round
At 28.3 gr. I started to notice slightly flattened primers, oddly at the time 28.5 gr only showed one slightly flattened primer only with the SST. Probably not an accurate measuring on my part. (May have spilled a bit out pouring into the case. I say that since the velocity was so low on two of them and i didn't have flattened primers on two of them.)
I think I will try and load more from 28.2 - 28.5 with .1 gr difference and see which one works out the best. Hopefully from a more sturdy rest on a less windy day.
Also, 26.1 gr. from the Nosler load data seemed to be pretty accurate only 200 FPS slower than close/near to max. I may use that as my nosler plinking fun round