little gunsmith info
|
little gunsmith info
|
03-20-2014, 06:10 AM
I have a bolt carrier that I want to put a POF roller cam pin in. The trouble is I need to remove the gas key screws to install the modified gas key that the roller requires. The staking only pushed metal against the screw heads not over their edge. I thought that even though the screws were staked this way they could be broken loose and though difficult backed out. Only problem is they won't even break loose. Anyone have any suggestions.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
little gunsmith info - by haustinv - 03-20-2014, 06:10 AM
little gunsmith info - by terrywick4 - 03-20-2014, 07:33 AM
little gunsmith info - by LRRPF52 - 03-20-2014, 07:35 PM
little gunsmith info - by cory - 03-20-2014, 08:50 PM
little gunsmith info - by montana - 03-20-2014, 09:11 PM
little gunsmith info - by haustinv - 03-21-2014, 03:34 AM
little gunsmith info - by cory - 03-21-2014, 03:57 AM
little gunsmith info - by Tedward - 03-21-2014, 12:56 PM
little gunsmith info - by LRRPF52 - 03-21-2014, 03:59 PM
little gunsmith info - by Kohoki - 03-21-2014, 09:00 PM
little gunsmith info - by LRRPF52 - 03-21-2014, 11:24 PM
|
