03-12-2014, 06:48 PM
I pulled my extracter and ejector,went over the corners with an india stone,then a ceramic stone and polished it up good.
No burrs or sharp edges to hang on the brass too long.
Put an extra strength wolf extracter spring in it also.
Haven't had a chance to shoot it yet but it ejects real good manually.
Think my stock spring was too light.
Going back to a H-2 buffer.
Measured where my 95 grain V-max stops and they came out with a COL of 2.185.
I'm going to try them with the AR comp seated 2.180.
If they shoot as good as the 85HP's I'll go with them.
They got a higher BC.
I think the CFE loads will work good now with better ejection.
No burrs or sharp edges to hang on the brass too long.
Put an extra strength wolf extracter spring in it also.
Haven't had a chance to shoot it yet but it ejects real good manually.
Think my stock spring was too light.
Going back to a H-2 buffer.
Measured where my 95 grain V-max stops and they came out with a COL of 2.185.
I'm going to try them with the AR comp seated 2.180.
If they shoot as good as the 85HP's I'll go with them.
They got a higher BC.
I think the CFE loads will work good now with better ejection.