Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
stronger bolt material for high pressure loads??
#44
Least we forget that inside of 200 yards bc is nearly irrelivent comparing the available 100gr barnes at .35 to a mythical magic bullet at .5 zeroed at 100 yards at 200 yards the .35 bc bullet has 4.3inches of drop compaired to 4.0 for the .5 bc bullet if you can't compensate for that much drop you shouldn't take the shot.... At 300 the .35 will hit 1.6 inches lower than the .5 bc
Punctuation is for the weak....
Reply


Messages In This Thread
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-20-2014, 06:53 PM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-20-2014, 08:22 PM
stronger bolt material for high pressure loads?? - by JASmith - 02-20-2014, 10:58 PM
stronger bolt material for high pressure loads?? - by JASmith - 02-20-2014, 11:41 PM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-21-2014, 12:00 AM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-21-2014, 12:12 AM
stronger bolt material for high pressure loads?? - by JASmith - 02-21-2014, 02:14 AM
stronger bolt material for high pressure loads?? - by JASmith - 02-27-2014, 07:09 PM
stronger bolt material for high pressure loads?? - by JASmith - 02-27-2014, 07:55 PM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-27-2014, 09:26 PM
stronger bolt material for high pressure loads?? - by woohoo - 02-28-2014, 02:45 AM
stronger bolt material for high pressure loads?? - by JASmith - 02-28-2014, 03:27 AM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-28-2014, 03:49 AM
stronger bolt material for high pressure loads?? - by JASmith - 02-28-2014, 04:22 AM
stronger bolt material for high pressure loads?? - by mongoosesnipe - 02-28-2014, 09:38 AM
stronger bolt material for high pressure loads?? - by JASmith - 02-28-2014, 03:22 PM
stronger bolt material for high pressure loads?? - by LRRPF52 - 02-28-2014, 03:43 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)