02-24-2014, 04:22 AM
Just purchased a TBAC 30 BA suppressor. The Barrel I have has 9/16-24 TPI.
I purchased a thread adapter to convert from 9/16-24 to 5/8-24.
screwed on thread adapter and there is still a gap between the barrel and the tread adapter even thought it is tight. It is only finger tight at this point. how do I shim it so that ther is no gap after I fully tighten it down n the barrel. or should I get different thread adapter.
I purchased a thread adapter to convert from 9/16-24 to 5/8-24.
screwed on thread adapter and there is still a gap between the barrel and the tread adapter even thought it is tight. It is only finger tight at this point. how do I shim it so that ther is no gap after I fully tighten it down n the barrel. or should I get different thread adapter.