6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Build-It-Yourself & Custom Builds v
Bolt lapping

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Bolt lapping
LRRPF52
Unregistered
 
#18
02-13-2014, 03:30 AM
Most smiths I know will turn the bolt on a press or lathe to square the face, using Dykem and a very light kiss, then polish it.
Reply


Messages In This Thread
Bolt lapping - by 45r - 01-22-2014, 06:39 PM
Bolt lapping - by burkew23 - 01-22-2014, 08:08 PM
Bolt lapping - by NugginFutz - 01-23-2014, 03:29 AM
Bolt lapping - by LRRPF52 - 01-23-2014, 06:18 AM
Bolt lapping - by explorecaves - 01-23-2014, 02:22 PM
Bolt lapping - by LRRPF52 - 01-23-2014, 05:48 PM
Bolt lapping - by customcutter - 01-23-2014, 08:09 PM
Bolt lapping - by 45r - 01-26-2014, 05:18 AM
Bolt lapping - by jurassic - 01-26-2014, 02:12 PM
Bolt lapping - by customcutter - 01-26-2014, 03:02 PM
Bolt lapping - by jurassic - 01-26-2014, 03:29 PM
Bolt lapping - by LRRPF52 - 01-26-2014, 11:23 PM
Bolt lapping - by BjornF16 - 02-13-2014, 12:39 AM
Bolt lapping - by montana - 02-13-2014, 02:33 AM
Bolt lapping - by cst - 02-13-2014, 03:04 AM
Bolt lapping - by LRRPF52 - 02-13-2014, 03:09 AM
Bolt lapping - by BjornF16 - 02-13-2014, 03:17 AM
Bolt lapping - by LRRPF52 - 02-13-2014, 03:30 AM
Bolt lapping - by BjornF16 - 02-13-2014, 03:48 AM
Bolt lapping - by LRRPF52 - 02-13-2014, 03:58 AM
Bolt lapping - by cst - 02-13-2014, 09:13 AM
Bolt lapping - by Tedward - 02-13-2014, 09:33 AM
Bolt lapping - by LRRPF52 - 02-13-2014, 04:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)