02-08-2014, 06:27 AM
calshipbuilder Wrote:yes, factory 123 amax, shot a bit over 1 moa
A few more questions, did you break your barrel in as Lilja recommends, is your gas block touching your hand guard at any point, are you sure your upper receiver face is square with your barrel ? It is hard to believe the barrel is the cause since your barrel came from the same lot as Peligroll3 and mine. It is obvious you can shoot good groups but I would re-check your rifle for any other problems. I cerakoted both my barrel and upper receiver which made my AA upper receiver and barrel fit perfectly. I would usually bed mine with loctite if it was any looser. I always lap my upper to check how square it is with my barrel extension. My upper and lower have zero play between them. Some hand guards have a small diameter and can touch the gas block when put on a rest or bipod. Hand guards do flex. I do know when shooting an AR plat forms it take more follow through than a bolt gun in my experience. Please let us know if you find any thing that makes a difference.