Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Of Reamers, Chambers, and Real World measurements
#4
so if you have a very well cleaned brand new barrel that you can NOT drop a factory hornady round without it sticking (and i dont mean just barely, you have to tap it out) due to the bullet touching the barrel, is it in spec or out? i have one like that but i really think i could tubbs it or just shoot it some and it would "clean" up that part of the barrel. of course as i hae stated already though my bolt is out of spec enough to not pass the go/no go gauges. it wont go but a LBC bolt will and i have more than one extra of those to try. my dilemma is should i just tubbs it or shoot it with a good bolt or not? i wish i had a great way to polish the throat that was perfect. and yes i have already contacted satern and they are more than willing to do whatever i deciede.
Reply


Messages In This Thread
Of Reamers, Chambers, and Real World measurements - by dammitman - 02-04-2014, 10:55 PM
Of Reamers, Chambers, and Real World measurements - by WildBill3/75 - 02-15-2014, 07:06 PM
Of Reamers, Chambers, and Real World measurements - by WildBill3/75 - 02-16-2014, 06:19 AM
Of Reamers, Chambers, and Real World measurements - by jurassic - 02-16-2014, 04:33 PM
Of Reamers, Chambers, and Real World measurements - by JASmith - 02-16-2014, 06:00 PM
Of Reamers, Chambers, and Real World measurements - by JASmith - 02-16-2014, 06:37 PM
Of Reamers, Chambers, and Real World measurements - by JASmith - 02-16-2014, 10:41 PM
Of Reamers, Chambers, and Real World measurements - by JASmith - 02-17-2014, 12:31 AM
Of Reamers, Chambers, and Real World measurements - by woohoo - 03-24-2014, 09:39 PM
Of Reamers, Chambers, and Real World measurements - by nincomp - 03-30-2014, 08:53 PM
Of Reamers, Chambers, and Real World measurements - by LRRPF52 - 03-31-2014, 08:50 PM
Of Reamers, Chambers, and Real World measurements - by JASmith - 03-31-2014, 09:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)