02-01-2014, 07:52 AM
alligator,
Welcome to the 6.5 Grendel Forum!
Like you, I recently shared my experience on the Forum, with a newly installed AR-Stoner 6.5 Grendel Barrel and Bolt http://www.65grendel.com/forum/showthrea...red/page48 (see Reply #473, third from top of Page). My measured Bolt face depth is 0.135". Fired cases do show some firing pin cratering, but no Ejector marks, nor nicks on the Bolt lugs, such as shown in your pics.
Question: After closing the Bolt on a fresh factory-loaded cartridge, then extracting it, are there any marks on the bullet, a short distance from the case neck, such as shown in my pic in the above-referenced Link?
Welcome to the 6.5 Grendel Forum!
Like you, I recently shared my experience on the Forum, with a newly installed AR-Stoner 6.5 Grendel Barrel and Bolt http://www.65grendel.com/forum/showthrea...red/page48 (see Reply #473, third from top of Page). My measured Bolt face depth is 0.135". Fired cases do show some firing pin cratering, but no Ejector marks, nor nicks on the Bolt lugs, such as shown in your pics.
Question: After closing the Bolt on a fresh factory-loaded cartridge, then extracting it, are there any marks on the bullet, a short distance from the case neck, such as shown in my pic in the above-referenced Link?