01-30-2014, 03:53 PM
Just unwrapped her yesterday. Looks fine overall, a few machining marks and a few mars, (perhaps i'm too critical), but nothing that will show thru cerakote.
Main issue i have, which may or may not be an issue, is there appears to be a bur in the barrel at the gas port. I don't have a bore scope but i *think* it is what i'm seeing when i shine a light thru the gas port hole. Now, when you look down the pipe, it is very clearly hanging down. Orients with the gas port hole which is why I am guessing that is what it is. It won't blow out with compressed air.
Should i just run a brush through and knock it out? Definitely don't want to do any damage before i get started. Advice?
Main issue i have, which may or may not be an issue, is there appears to be a bur in the barrel at the gas port. I don't have a bore scope but i *think* it is what i'm seeing when i shine a light thru the gas port hole. Now, when you look down the pipe, it is very clearly hanging down. Orients with the gas port hole which is why I am guessing that is what it is. It won't blow out with compressed air.
Should i just run a brush through and knock it out? Definitely don't want to do any damage before i get started. Advice?