01-12-2014, 02:55 AM
Does the claw end of the extractor lay below flush?
It sounds to me like the extractor is pivoting in too far. It may prevent the rim from making its way into the bolt recess.
Since different extractors act the same in each bolt, the cutout in the bolt is probably too deep. The pin location is probably OK, or the bolt wouldn't fit in the carrier at all.
You may try building up the cutout in the bolt with Devon or JB Weld, or you could add some to the extractor. You could put on extra and sand it down till the extractor laid flush.
It sounds to me like the extractor is pivoting in too far. It may prevent the rim from making its way into the bolt recess.
Since different extractors act the same in each bolt, the cutout in the bolt is probably too deep. The pin location is probably OK, or the bolt wouldn't fit in the carrier at all.
You may try building up the cutout in the bolt with Devon or JB Weld, or you could add some to the extractor. You could put on extra and sand it down till the extractor laid flush.