01-11-2014, 03:04 PM
Sputnik Wrote:Has anybody had any difficulties inserting their bolt into their bolt carrier? I could not insert by bolt until I noticed that the extractor tail measured .015 inches above the rest of the bolt surface. I lifted the claw up to lower the tail and it slid in. Will this cause undo wear to the bolt carrier or to my extractor tail? I matched it to my AA bolt and my PF bolt and they all were flush or lower than the bolt surface. I am thinking I may wait for my Maxim bolt and use this one as a backup.
You might want to contact Satern and see if they found a few like that. They also might have bolts in stock they can swap it out for if its a bad one. They bought from someone, not to say it was or wasn't Underground so let them be the liaison between there vendors. JMO and that is what I would do.