6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Build-It-Yourself & Custom Builds v
Scope mounting???

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Scope mounting???
customcutter
Unregistered
 
#8
01-04-2014, 12:34 AM
I guess I could mount the upper and handguard together and put them on my 24" surface plate and see if the top is flat. If everything is flat, I could try to figure some way to measure if there was any flex in the set-up.
Reply


Messages In This Thread
Scope mounting??? - by customcutter - 01-03-2014, 10:09 PM
Scope mounting??? - by explorecaves - 01-03-2014, 10:26 PM
Scope mounting??? - by NugginFutz - 01-03-2014, 10:46 PM
Scope mounting??? - by Walter - 01-03-2014, 10:56 PM
Scope mounting??? - by customcutter - 01-03-2014, 11:23 PM
Scope mounting??? - by Walter - 01-04-2014, 12:06 AM
Scope mounting??? - by montana - 01-04-2014, 12:32 AM
Scope mounting??? - by customcutter - 01-04-2014, 12:34 AM
Scope mounting??? - by stanprophet - 01-04-2014, 12:35 AM
Scope mounting??? - by customcutter - 01-04-2014, 12:39 AM
Scope mounting??? - by tackdriver - 01-04-2014, 01:02 AM
Scope mounting??? - by kamrr4437 - 01-04-2014, 02:02 AM
Scope mounting??? - by NugginFutz - 01-04-2014, 02:57 AM
Scope mounting??? - by customcutter - 01-04-2014, 04:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)