01-01-2014, 04:19 PM
Tedward Wrote:I'm using Nordic Components and any that have a barrel nut that locks to the upper and has a lock ring the barrel butts to. I happen to mill the back of the barrel nut to give it a different look but you don't have to. The black ring is the stop collar.
Check this out. http://nordiccomp.com/retail/shop/ar-15-...-guard-xl/
YHM also uses this type of Barrel Nut. If you use a Troy, you have to cut off a tiny anti rotation tab and I have done that for many models. Just make sure you tighten everything very tight. I have had no issue, it way stronger than any plastic HG so your definitely up one on that.
[ATTACH=CONFIG]4360[/ATTACH]
What wrench did you use to tighten the lock nut on your handguard. I cold not find a spanner wrench that fit it well. Nice looking rifle!