Best Lower?

[Tedward]

I ran into this problem also with my MEGA side charging upper. I had grown so accustom to the B.A.D. lever I didn't want to go without it. This was long before I knew about the Phase 5 lever so my solution was to mill a small amount of material so the B.A.D. lever would fit.



I have received the PSA lowers I mentioned and they look great. They were sold as "blemished" but I couldn't find anything I would call blemishes. I also recently purchased a 80% polymer lower from polymer80.com for a lightweight build for my daughter. I have not started it yet but initial impressions are good. I'll post pics of it as we make progress on it. This will be her rifle that she will build (under my close supervision of course).

After you milled the pocket area I can see it is black again. What did you finish it with? Did you paint the entire upper or get a anodizing touch up kit?