12-30-2013, 02:02 PM
Nukes Wrote:Truly! Of all the simple pieces of metal, the Magpul B.A.D. lever is my favorite accessory—and it does not fit our Seekins lowers :-(
On our Seekins Grendel, the length of the projection on their standard bolt release lever interferes with release and hold-open. They make a special order bolt release lever that has solved those problems, but it does not fit the B.A.D. lever.
I have been eyeing the B.A.D. lever and the metal file in my tool chest, but have not yet laid hand to task.
I ran into this problem also with my MEGA side charging upper. I had grown so accustom to the B.A.D. lever I didn't want to go without it. This was long before I knew about the Phase 5 lever so my solution was to mill a small amount of material so the B.A.D. lever would fit.
![[Image: IMAG2885.jpg]](http://i67.photobucket.com/albums/h302/jtdavis00/IMAG2885.jpg)
I have received the PSA lowers I mentioned and they look great. They were sold as "blemished" but I couldn't find anything I would call blemishes. I also recently purchased a 80% polymer lower from polymer80.com for a lightweight build for my daughter. I have not started it yet but initial impressions are good. I'll post pics of it as we make progress on it. This will be her rifle that she will build (under my close supervision of course).
NRA life, GOA life, SAF, and TSRA
"I ask, Sir, what is the militia? It is the whole people, except for a few public officials. To disarm the people is the best and most effectual way to enslave them."
George Mason, co-author, 2nd Amendment.
"I ask, Sir, what is the militia? It is the whole people, except for a few public officials. To disarm the people is the best and most effectual way to enslave them."
George Mason, co-author, 2nd Amendment.