It just might work
|
It just might work
|
08-07-2011, 07:51 AM
Pics of the machining to the YHM rail. Contrary to what I'd feared, there's plenty of meat on this thing. A deep 1/2" cut on each end and a shallower groove connecting them. The barrel nut got the same treatment as the one the other guy did with his LaRue rail. While the machining essentially doubled the cost of the rail, I think the effect was worth it. I'll be finishing assembly tomorrow (I hope) and will post pics of the finished build tomorrow evening.
![[Image: railmachining03.png?t=1312703110]](http://i29.photobucket.com/albums/c253/TheOTHERmaninblack/generic/railmachining03.png?t=1312703110) ![[Image: railmachining02.png?t=1312703110]](http://i29.photobucket.com/albums/c253/TheOTHERmaninblack/generic/railmachining02.png?t=1312703110) ![[Image: railmachining01.png?t=1312703110]](http://i29.photobucket.com/albums/c253/TheOTHERmaninblack/generic/railmachining01.png?t=1312703110)
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
It just might work - by TheOTHERmaninblack - 08-04-2011, 10:44 PM
It just might work - by TheOTHERmaninblack - 08-07-2011, 07:51 AM
It just might work - by TheOTHERmaninblack - 08-15-2011, 09:54 AM
It just might work - by txgunner00 - 08-16-2011, 05:24 AM
It just might work - by TheOTHERmaninblack - 08-16-2011, 10:34 PM
It just might work - by txgunner00 - 08-16-2011, 11:00 PM
It just might work - by leopard6.5 - 08-17-2011, 12:36 AM
It just might work - by TheOTHERmaninblack - 08-17-2011, 01:00 AM
It just might work - by leopard6.5 - 08-17-2011, 01:39 AM
It just might work - by TheOTHERmaninblack - 08-17-2011, 09:21 AM
|
