Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My First Little Monster
#6
As long as the gas block provides a good seal, is aligned properly, and has the tube hole and roll pin holes drilled correctly, it will be fine.

I've been using YHM lo-profile blocks for a while, but the VLTOR clamp-on is a higher end unit. You will be limited with internal clearance with the Troy Alpha, so low-profile set screw is usually the route people go with that handguard.

Your 15" handguard is going to cover the gas block.
Reply


Messages In This Thread
My First Little Monster - by aclark - 12-09-2013, 09:18 PM
My First Little Monster - by aclark - 12-09-2013, 09:44 PM
My First Little Monster - by LRRPF52 - 12-09-2013, 10:17 PM
My First Little Monster - by aclark - 12-09-2013, 10:27 PM
My First Little Monster - by cory - 12-09-2013, 10:34 PM
My First Little Monster - by LRRPF52 - 12-09-2013, 10:36 PM
My First Little Monster - by montana - 12-10-2013, 12:01 AM
My First Little Monster - by LRRPF52 - 12-10-2013, 12:18 AM
My First Little Monster - by aclark - 12-10-2013, 12:55 AM
My First Little Monster - by montana - 12-10-2013, 01:16 AM
My First Little Monster - by aclark - 05-19-2014, 03:20 AM
My First Little Monster - by JASmith - 05-19-2014, 12:39 PM
My First Little Monster - by aclark - 05-19-2014, 08:49 PM
My First Little Monster - by JASmith - 05-19-2014, 11:58 PM
My First Little Monster - by Rugerfan.64 - 05-20-2014, 02:46 AM
My First Little Monster - by aclark - 05-20-2014, 03:30 AM
My First Little Monster - by aclark - 10-20-2014, 09:22 PM
My First Little Monster - by lamrith - 10-20-2014, 09:54 PM
My First Little Monster - by aclark - 10-20-2014, 10:04 PM
My First Little Monster - by lamrith - 10-21-2014, 03:17 AM
My First Little Monster - by aclark - 10-21-2014, 10:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)