12-04-2013, 03:06 AM
LRRPF52, Tedward:
thanks for the pics and link. If I were going to be building AR's regularly I would buy tools. However, this may be my one and only, unless I decide to do a 6X45. I think I'll fire up the mill and make a block. May also fire up the lathe and make a roll pin holder out of some W-1.
LRRPF52:
What is the purpose of rounding the edges on the ejector pin? Is that one of the things that dings up the brass, that I've read about? I know the other was to put velcro on the brass deflector.
thanks for the pics and link. If I were going to be building AR's regularly I would buy tools. However, this may be my one and only, unless I decide to do a 6X45. I think I'll fire up the mill and make a block. May also fire up the lathe and make a roll pin holder out of some W-1.
LRRPF52:
What is the purpose of rounding the edges on the ejector pin? Is that one of the things that dings up the brass, that I've read about? I know the other was to put velcro on the brass deflector.