6.5 Grendel Forum › 6.5 GRENDEL DISCUSSION FORUMS › 6.5 Grendel Build-It-Yourself & Custom Builds v
Rear take down pin trouble??

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Rear take down pin trouble??
Lead Chucker
Unregistered
 
#17
12-02-2013, 08:33 PM
A buddy had one like that this year, pin wouldnt go through the far side. We found the pin was out of spec by a few thousandths. Some 600 grit sandpaper and a few minunts later it fit fine. Like said above alittle tight is better than slop.
Reply


Messages In This Thread
Rear take down pin trouble?? - by customcutter - 11-30-2013, 09:58 PM
Rear take down pin trouble?? - by cory - 11-30-2013, 10:43 PM
Rear take down pin trouble?? - by customcutter - 11-30-2013, 10:49 PM
Rear take down pin trouble?? - by NugginFutz - 11-30-2013, 11:41 PM
Rear take down pin trouble?? - by customcutter - 11-30-2013, 11:57 PM
Rear take down pin trouble?? - by LRRPF52 - 12-01-2013, 12:50 AM
Rear take down pin trouble?? - by customcutter - 12-01-2013, 12:58 AM
Rear take down pin trouble?? - by LRRPF52 - 12-01-2013, 01:32 AM
Rear take down pin trouble?? - by customcutter - 12-01-2013, 02:20 AM
Rear take down pin trouble?? - by NugginFutz - 12-01-2013, 02:44 AM
Rear take down pin trouble?? - by ricsmall - 12-01-2013, 02:46 AM
Rear take down pin trouble?? - by LRRPF52 - 12-01-2013, 04:19 AM
Rear take down pin trouble?? - by customcutter - 12-01-2013, 06:57 PM
Rear take down pin trouble?? - by jurassic - 12-01-2013, 08:06 PM
Rear take down pin trouble?? - by NugginFutz - 12-01-2013, 08:47 PM
Rear take down pin trouble?? - by Tedward - 12-01-2013, 09:17 PM
Rear take down pin trouble?? - by Lead Chucker - 12-02-2013, 08:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)